Meltblown cloth inspection fails

There are many reasons why the melt-blown cloth inspection fails to meet the standard. You can find the problem from the following aspects. First, see if the production environment of the plant is required. It is impossible to produce products that meet the standard in a dirty and messy environment. Second, whether the raw materials are qualified. Nowadays, many unqualified melt-blown materials produced by small factories are impossible to produce products that meet the standard; Third, whether the parameters of the production equipment can meet the requirements of producing this level of meltblown cloth. Fourth, the equipment meets the requirements and whether the parameters are qualified for debugging. Many manufacturers do not pay attention to this point, and think that they can produce high-quality equipment by paying a high price for high-level equipment. In fact, this is not the case. Multiple parameters between multiple components of melt-blown cloth production equipment must be closely coordinated to produce standard products. Please have a rich experience of the machine master to spend enough time debugging to produce the best product. Fifth, the current domestic melt-blown cloth production equipment is mostly produced by electromechanical companies with adhesive edges (even some non-stick-edge companies). There is no historical precipitation of important parameters of melt-blown cloth production equipment, and many key components With mature supply channels, the purchased components simply do n’t have time to test. The equipment is now a seller ’s market, and the equipment can produce meltblown cloth.